Jun 05, 2024 Leave a message

Common Components of Crankshaft

A crankshaft comes with several parts that work simultaneously to make it work. Without these parts, the crankshaft becomes just a piece of metal. The parts of the crankshaft include main journals, counterweights, flywheel mounting flange, thrust washers, crank pins, crank webs, oil passage, and seals. Below are the crankshaft parts and functions in detail.

 

1. Main Journals

The crankshaft journals provide a point of attachment to the engine block. They feature bearings that help hold the crankshaft in place while allowing the engine block to rotate around it. There are two types of bearings found in the main journals. They are journal bearings and plain bearings.

 

There are different types of main bearings, and they vary between engines. The bearing type found in an engine depends on its torque.

 

2. Counterweights

These are weights mounted on the crank web whose major role is applying the opposite force. In other words, counterweights provide much-needed stability and balance to the crankshaft.

 

Also, when the crankshaft rotates, a reaction could reduce the engine's speed. However, counterweights help eliminate these reactions, helping the crankshaft achieve a high RPM.

 

3. Flywheel Mounting Flange

The Flywheel mounting flange is the point of attachment between the crankshaft and the flywheel. The flywheel flange part of the crankshaft is often larger than the other end, providing a face for mounting the flywheel.

 

4. Crank Pin

This part of the crankshaft facilitates a strong connection between the connecting rod and the crankshaft. Other names for this component are connecting rod journal and rod bearing journal. Crank pins always have a cylindrical surface. This surface ensures the pin flows with the rotating force found on the piston rod's bigger end.

 

5. Crank Web

The crank web helps connect the main bearing journals to the crankshaft. This component of the crankshaft is of utmost importance.

 

6. Thrust Washers

Without thrust washers, the crankshaft would move vertically, in addition to its rotational motion. So, to prevent this, there are two or more thrust washers at strategic locations along the length of the crankshaft. There are also washers between the web's surface and the crankshaft saddle to maintain specific clearance between the crank web and shaft.

 

Older engine types use separate thrust washers, but for newer ones, the washers are components of the main journal bearing.

 

7. Oil Seals

Due to the crankshaft extending beyond the crankcase on both ends, openings exist on these ends. One way to prevent oil from seeping out of the crankshaft is by using oil seals. There are two main oil seals in the crankshaft, one in front and the other at the rear. The front-end oil seals find their place behind the pulley and timing gear. This oil seal is accessible, making it easy to change.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry